Restaurant Movable Wooden Soundproof Folding Sliding Partition Walls Malaysia

How to open a multi-directional screen

All operations should be gentle and should pay attention to safety. Facing the screen station, use both hands to grab the screen and pull the screen in the direction of the rails; turn the screen in the direction of the rails.

After pushing the screen to its place, fix the screen. Tip: When pushing the screen to the intersection, you should pay attention to the direction of the rail, and then gently push the screen along the rail to the position where it should be placed.

How to fix a multi-directional screen

Hold the screen with one hand, and put the handle in the hexagonal steel at the 1100mm side of the screen side material (the position shown in Figure 3), and hold the handle and turn it clockwise by 180 degrees (or continuously shake). ;, The telescopic seal inside the screen will pop up to fix the screen.
Insert the handle into the groove on the side of the screen, and pull the handle upwards to open the expansion screen inside the screen to fix the screen. After putting the entire group of screens, check if the screen is straight? Whether it is on the same plane as the rail, if not straight, retract the upper and lower expansion seals and adjust until the screen is straight.

How to operate multi-directional telescopic panel screen

Usually, the last side of each group of screens is a retractable screen. Push the screen to the position where it should be placed. Then move the handle up and down in the side groove to pop up and down the active seal (as shown in Figure 1). Show the position), and then put the handle in the operation hole on the surface of the telescopic screen, and rotate it counterclockwise until the side of the telescopic aluminum plate is pressed against the wall.

How to operate the multi-directional screen pass door

Put the door in the door to the position where it should be placed and the screen in front of it touches tightly. Insert the handle into the groove on the side of the screen, and pull the handle upwards to open the telescopic seal on the inside of the screen to fix the screen. Open the small door, insert the handle into the operation hole of the door leg on the other side of the screen, and pull the handle upwards to open the expansion screen on the other side of the screen to fix the screen.

How to accept multi-directional screen

1. If there is a door in the door, first turn the square hole on both sides of the door to rotate 180 degrees, loosen the upper and lower seals through the transmission wheel, and then close the door in the door;

2. open the last screen of the retractable aluminum plate and the top and bottom seals;

3. Retract the retractable aluminum panel of the last screen so that its distance can at least turn the distance of the screen;

4. Push the screen in the direction of the rails to the position of the screen.

5. After each group of screens is collected in the same way, press each two screens tightly to minimize the distance between the screens and the screens. If necessary, you can open the up and down motion seals of the last screen that is housed at the hidden plate so that it presses against the rails and the ground. This will prevent other people from simply pulling the screen out.

Technical data of Type 65 movable partition