2800mm Carton Box Stitching Machine Box Corrugated Stitcher Paper Carton Making Machine

Semi Automatic Box Corrugated Stitcher Paper Carton Making Machine

14. After the carton is formed, the length of the upper and lower covers is not neat. The toothed belt is seriously worn up and down, and the gap between the two sides is too large or different. The paper feed is not sent to the baffle for positioning, and the switch is stepped on the nail. The carton pressure line is not deep enough, and the carton is too skewed before being twisted. Maintenance The semi-automatic nail box has a low failure rate and high reliability. Maintenance is very important, so do the following:
1) The upper nail head punches once a day, and the nail head is cleaned and refueled every 30 days.
2) The lower nail head accumulates in the punch due to the small wire plating of the nail line, so it must be cleaned frequently, the nail head must be removed, and the oil is replaced after cleaning.
3) Feeding belt, bolting shaft, left and right bezel, three gears, buttering once in 30 days
4) Clutches and brakes must not have oil or water
5) The servo motor must be kept clean to avoid dust cover. Always clean the servo motor drive cooling filter net.
6) Electrical control box keeps clean and avoids short circuit caused by dust
7) The inner and outer wire spools should be flexible and lubricated with butter.
8) The nail head fixed shaft and the left and right baffle fixed shafts must be cleaned and oil lubricated when moving
9) Upper and lower nail head drive shaft, bolt groove shaft, transmission screw oil lubrication
10) In the power transmission box, the gear and chain are greased for 30 days.

Semi-automatic nail box machine troubleshooting
The nail box is the last production process of carton forming, and its process effect affects the appearance quality of the carton on the one hand, and affects the use performance of the carton on the other hand. From the perspective of production technology, the nail box seems to be a relatively simple process. However, in daily production, it is inevitable to expose some quality problems. Therefore, the technical and quality control of the nail box process cannot be ignored. It is necessary to pay attention to the serious control and control from the aspects of equipment purchase, operation technology and material selection. Better prevent or reduce the chance of quality problems.

In the nail box, it will be found that when the quality of the flat wire is not good, the wire feeding resistance is large, the wire spring is too loose or too tight, the wire fixing screw is loosened, the guide rail is deflected, the gear bite is skewed, and the bottom die is fixed. When the position of the punch is not correct and the bottom mold has obvious wear and the like, the above-mentioned malfunction phenomenon is likely to occur. In this regard, the solution is to use high-quality flat wire with good rigidity and smooth surface coating; check whether the parts of the wire are poorly adjusted and cause jamming; adjust the relevant parts of the machine to make the wire movement easy and comfortable; The serious bottom mold should be repaired or replaced accordingly.

Machine specification

Hebei Jinguang Packing Machine Co.Limited is a professional corrugated carton printing equipment and related machinery for carton production over ten years.Our company is located in the Lisiwei industrial part ,Dongguang country Hebei Province.Our main products are corrugated carton box printing,slotting,die cutting machine (simiauto,automatic).Middle high speed corrugated paperboard production line,automatic folder gluer machine,stitching machine,flute laminator ,thin blade slitter,partition machine ,automatic assemble machine,binding machine and so on.