Mechanical Equipment 3 Inch Industrial Swivel Casters 1477lbs

Castor products castor seat treatment quality management
1, Contents and methods of incoming inspection:

1) Visual inspection for appearance: whether there are cracks, bumps and rust spots.

2) Investigate the material of the workpiece: check the way of grinding spark

3) If there is deformation, check the original deformation.

2, Contents and methods of first inspection, intermediate sampling inspection and castor

inspection:

1. Hardness

1) Hardness inspection or sampling inspection shall be carried out according to the drawing

requirements and process regulations. Calibrate the hardness tester with a standard block and test

the hardness after confirmation. Quenched parts shall be inspected with Rockwell hardness tester.

2) Before hardness inspection, the part surface shall be cleaned to remove oxide scale,

decarburization layer and burr, and there shall be no obvious machining marks on the surface. The

temperature of the tested part shall be subject to room temperature, or slightly higher than room

temperature, but only if it can be grasped stably by hands.

3) The hardness testing position shall be determined according to the process documents or by the

inspection and process personnel. The hardness of quenched parts shall not be less than 1 place,

each place shall not be less than 3 points, and the non-uniformity of general hardness value shall

be ≤ HRC 5 degrees.

2. Deformation
1) The flatness of thin plate parts shall be inspected with feeler gauge on the inspection platform.

2) Both ends of shaft parts shall be supported by the center or V-block, and their radial runout

shall be measured with a dial indicator. Small shaft parts can be checked with a feeler gauge on the

platform.

3) For ring parts, use dial gauge, vernier caliper, plug gauge, inner diameter dial gauge, thread plug

gauge, ring gauge, etc. to check the dimensions of the outer circle, inner hole and thread of the parts.

4) Special testing tools for non-standard measured threads and special parts.

3. Appearance: observe the surface with naked eyes for cracks, burns, bumps, pits, corrosion, etc.

Important parts or parts prone to cracks shall be inspected by means of kerosene immersion and

sand blasting.

4. Performance: testing equipment.

3, Inspection contents and methods of permanent deformation of caster base plate:

1. Compress (stretch and twist) the finished caster base plate five times to the height (length or

working limit torsion angle) under the working limit load, and measure the height (or length and

angle) for the fourth and fifth times. If the value remains unchanged, it is considered that there

is no permanent deformation.

2. The inspection of the load and dimensional tolerance, surface shape and position tolerance

of the finished caster base plate shall be carried out after the inspection of permanent deformation,

but the load and dimensional tolerance shall also be qualified before the permanent deformation.

3. Fatigue test, impact test and simulation test of caster base plate: Test of testing equipment.

4. The surface quality of caster base plate shall be measured visually.

Industrial Swivel Casters Parameter

Industrial Swivel Casters Describe

Industrial Swivel Casters Size

Industrial Swivel Casters Material

Industrial Swivel Casters Scope of application

Application.

About us.

KTC.

The company is headquartered in the Shunyi District Niushan Industrial Zone, Beijing ,The company adopts advanced international production testing equipment and professional intelligent production management system and professional process flow,Current production KT Casters（KT CASTER）,KT Adjusting foot（KT FOOT）High quality products such as multi function,High quality horizontal adjustment of the casters,Shock proof casters,High load casters ,The adjusted feet are widely used in the world's advanced automation equipment and semiconductor equipment and other industries. The company is making the world's highest level of product,Use the most advanced processing technology and equipment,New products emerge in an endless stream.KTC sales network is all over the world,And has set up a company in South Korea,Favored by users from all walks of life around the world