128x64 0.96 Inch OLED Display Bicolor SSD1306 30PIN Serial Interface

0.96 Inch OLED Display Bicolor 128x64 Resolution SSD1306 30PIN Serial Interface

Electrical Specifications:

• Interface:

  • I²C (2-wire) or SPI (4-wire) depending on the module (check before purchase).

  • The I²C interface uses two pins (SCL and SDA) for communication, while SPI uses more (MOSI, MISO, SCK, and CS).

• Power Supply: 3.3V to 5V.

• Current Consumption:

  • Typically, 20-30mA at full brightness.

  • Power consumption reduces significantly with lower brightness or black screens (because OLED is self-emitting).

Display Characteristics:

• Contrast Ratio: Excellent, with true blacks because the OLED pixels can be completely turned off.

• Refresh Rate: Fast enough for smooth text and simple graphics (refresh rates of ~60Hz or higher are typical).

• Font Rendering: Great for displaying text in small sizes, and can support basic pixel graphics.

• Response Time: Fast response times with no motion blur.

Detailed Parameters:

OLED Screens ( 0.42 inch~3.12 inch ):

We mainly develop small-middle sizes OLED displays, including 0.42", 0.49", 0.66", 0.78", 0.87", 0.91", 0.96", 1.12", 1.21", 1.3", 1.5", 1.54", 1.92", 2.08", 2.23", 2.42", 2.7", and 3.12", etc.

Pinout (for I²C):

The common pinout for a 0.96-inch SSD1306 OLED (I²C) display is:

1. VCC: Power supply (3.3V or 5V depending on your system).

2. GND: Ground.

3. SCL: Serial Clock Line (for I²C communication).

4. SDA: Serial Data Line (for I²C communication).

5. RES: Reset (optional depending on the module).

6. DC: Data/Command (used to indicate if the sent data is a command or display data).

7. CS: Chip Select (used for SPI interface, not needed for I²C).

For SPI, you would also need MOSI, SCK, and CS.