CE 2 Wire Conventional Thermal Detector For Fire Security Fire Fighting System

Introduction

The key difference between heat detectors and smoke detectors is that heat detectors respond to an increase in temperature, while smoke detectors respond to the presence of smoke particles. Heat detectors are often used in environments where smoke detectors may be prone to false alarms, such as in kitchens or workshops.

A conventional heat detector is a standalone safety device designed to sense an increase in ambient temperature and trigger an audible alarm to alert occupants of a potential fire.

It can be compatible with other brand conventional fire alam system.

Parameters

INSTALLATION
NOTE: All wiring must conform to applicable local codes, ordinances, and regulations.
NOTE: Verify that all detector bases are installed, that the initiating-device circuits have been tested, and that the wiring is correct.
Remove power from initiating-device circuits before installing detectors.
1. Wire the sensor base per the wiring diagram, Figure 1.
2. Install the sensor into the sensor base. Push the sensor into the base while turning it clockwise to secure it in place.
3. After all sensors have been installed, apply power to the control unit.
4. Test the sensor(s) as described in the TESTING section of this manual.
5. Notify the proper authorities that the system is in operation.

Warning:Forbid connect 24VDC directly without current-limiting resistance. Otherwise, the detector would be burnt out.

Product range

Conventional Fire Alarm System
Addressable fire alarm system
Gas Extinguishing control system
Beam Detector
4 wire smoke detectors with relay output.
2 wire Conventional smoke and heat detectors
Explosion-proof flame detector for fire alarm system
Standalone smoke detectors and combustable gas detector

Service

1. OEM &ODM service.
2. Provide technical support and after-sale service.
3. 1 year warranty.
4. Normally 15 working days lead time.
5. Welcome sample order.