| Ratings | Rated Voltage (MAX) | 50V | |
| Rated Current (MAX) | 0.5A [AC/DC(effective value)50Hz] | |
| Ambient Temperature Range | -45 +85 | |
| Electrical Performance | Contact Resistance | 20 m MAX | Mate applicable FPC/FFC and measure by dry circuit, 20mV MAX, 10mA. |
| Insulation Resistance | 500M MIN | Mate applicable FPC/FFC and apply 500V DC between adjacent terminal
or ground. |
| Dielectric Strength | No Breakdown | Mate applicable FPC/FFC and apply 200V AC (virtual value) for 1
minute between adjacent terminal or ground. |
| Mechanical Performance | Locking Force | 1.96*n (N) MAX | Insert and extract applicable FFC (0.3mm thickness) at the speed
rate of 253mm/minute. |
| Withdrawal Force | 0.49*n (N) MIN | Insert and extract applicable FFC (0.3mm thickness) at the speed
rate of 253mm/minute. |
| Terminal/Housing Retention Force | 3.92N MIN | Pull the terminal at the speed rate of 253mm per minute. |
| Environmental Performance | Repeated Insertion and Withdrawal | Contact Resistance 60 m MAX | Insertion and withdrawal actuator up to 20 cycles at the speed rate
of less than 10 cycles/minute. |
| Temperature Rise | 30 MAX | Carrying rated current load. (UL 498) |
| Vibration | Contact Resistance 60 m MAX; Discontinuity 1 ms MAX; No Damage | DC 1mA energized state; Vibration along XYZ axes, amplitude 1.5mm;
Frequency 10-55-10Hz/min; Duration 2 hours. |
| Shock | Discontinuity 1 ms MAX; No Damage | DC 1mA energized state; 490m/s{50G} shock in 6 directions; 3 times
each. |
| Heat Resistance | Contact Resistance 60 m MAX; No Damage | Mate applicable FPC/FFC; Place in 852 air for 96 hours; Return to
room temperature for 1-2 hours. |
| Cold Resistance | Contact Resistance 60 m MAX; No Damage | Mate applicable FPC/FFC; Place in -402 air for 96 hours; Return to
room temperature for 1-2 hours. |
| Humidity | Insulation Resistance 20 M MIN; No Damage | Mate applicable FPC/FFC; Place in 402, 90-95% RH for 96 hours;
Measure within 0.5 hours after returning to room temperature. |
| Temperature Cycling | Contact Resistance 60 m MAX; No Damage, Corrosion | 5 cycles of: -452 (30 min) -> Room Temp (10-15 min) -> 852
(30 min) -> Room Temp (10-15 min). |
| Salt Spray | Contact Resistance 60 m MAX; No Damage | 484 hours exposure to a salt spray from the 51% solution at 352.
After test, wash with room temperature water and dry. |
| SO2 Gas Resistance | Contact Resistance 60 m MAX; No Damage | 24 hours exposure to 505ppm SO2 gas at 402. |
| NH3 Gas Resistance | Contact Resistance 60 m MAX; No Damage | 40 minutes exposure to NH3 gas evaporating from 28% Ammonia
solution. |
| Solder Ability | Solder Wetting | 95% wetting area | Immerse terminal tip 0.2mm into 2355 tin bath for 20.5 sec. |
| Resistance to Soldering Heat | No Damage, Deformation | Immerse terminal tip 0.2mm into 2605 tin bath for 50.5 sec. |
