OID 5000mAh 75C Discharge LiPo Battery with 160A Continuous Current for RC Drones & FPV

Engineered by Jianheng (Shenzhen Jianheng Technology Co Ltd), the OID7548145-5000-3.7V-75C is a high-performance lithium polymer battery designed for RC drones, FPV racing, and other high-drain applications. With a 75C continuous discharge rating and 160A max constant current, it delivers reliable power when you need it most.

This battery is ideal for RC drones, FPV racing drones, RC cars, helicopters, and other high-performance models requiring a 1S (3.7V) 5000mAh pack with extremely high discharge capability (160A continuous).

Use a quality LiPo charger with CC/CV mode. Standard charge: 2.5A (0.5C) to 4.2V, then CV until current drops to ≤0.05C. Max charge rate is 15A (3C). Never charge above 4.2V or below 0°C. Always use a balancing charger if multiple cells are present.

Yes, the OID 5000mAh 75C battery supports 160A constant discharge down to 3.0V cutoff. For peak loads (≤3 seconds), up to 200A is allowed. Ensure your application and wiring can handle such high current.

This LiPo pack includes overcharge, over-discharge, and short-circuit protection via proper usage. However, you must avoid physical damage, reverse polarity, direct soldering on the cell, or use near fire/heating sources. Always store at 3.7V-3.9V when not in use for long periods.

Store at 0°C~35°C, ≤75% RH, with approximately 30-60% state of charge (3.7V~3.9V). Recharge every 3 months to maintain voltage range. Do not store fully charged or fully discharged.

Under standard cycling (2.5A charge/discharge to 4.2V/3.0V), the battery retains >80% of initial capacity after 300 cycles. Proper usage and storage extend lifespan.

While the specification sheet doesn't list specific certifications, the battery meets standard safety requirements for vibration, drop test, and temperature performance. Contact us for specific certification needs.

Discharge is allowed down to -20°C, but capacity will be reduced (approx. 70% at -10°C). Charging is only permitted between 0°C and 60°C to avoid damage.

For more technical support, contact Jianheng: alan@liion-batt.com | Tel: 0086 137 2555 9416 | Address: 20F 2# Bld. Zhenhuan Rd. Pingshan, Shenzhen, China.