Multi-Shot Cable Fault Locator Tdr Cable Tester with Customization
|
XHGG502 Product Introduction The XHGG502 ARC cable fault locator is suitable for measuring the low resistance, short circuit, open circuit and disconnection faults of various materials of different cross-sections and different media, high-frequency coaxial......
Xi'an Xu&Hui Electromechanical Technology Co., Ltd.
|
wholesale tdr cable fault locator fiber optic light laser pointers wire tester
|
Model: HY-16 Length: 21.75cm Product Description: measure laser point fiber optic tester laser optical fiber light pen adopt 650nm laser diode as a light emitting device, the output power can be up to 1mw-30mw. It’s applied to single-mode or multi-mode ......
Henan Huachuang Communication Equipment Co.Ltd.
|
IEC60245 Cable Tester With Universal Conductor Resistance, Providing Reliable Testing.
|
... voltages up to and including 450/750 V) and IEC60245-2 (Test methods for rubber insulated cables with rated voltages up to and including 450/750 V). Application Scope Suitable for DC resistance measurement of various power cables and electrical equipment....
Guangzhou HongCe Equipment Co., Ltd.
|
220V Cable Testing Equipment Intelligent TDR Underground Cable Locator
|
...Cable Testing Equipment Intelligent TDR Underground Cable Locator Product Description RSDGC-3H adopts present international advanced “multi-times pulse” technology, self-developed test technology and the device for high- frequency and high- voltage data signal. Equipped with the best cable fault waveform judgment ability and the most simple and convenient operating system. Multi-pulse method greatly simplifies the fault waveform measured...
Wuhan Rising Electric Co., Ltd.
|
Wire / Cable Smoke Density Tester For Needle Flame Test IEC61034
|
...Cable Smoke Density Tester, IEC61034 Cable Tester and Wire Tracker Product description: Test the smoke density of the wires and cables Test index: Optical density(OD) and specific optical density(DS) of the smoke Measuring principle: Lambert-beer Law Measuring method: Measure......
DONGGUAN YUYANG INSTRUMENT CO., LTD
|
IEC 61034 HH52114 3M Cube Cable Testing Machine
|
...Cable) Smoke Density Tester Product description: 3M cube smoke density tester is used for measurement of smoke density of cables burning under defined conditions Test index: Optical density (OD) and specific optical density (DS) of the smoke Measuring principle: Lambert-beer Law Measuring method: Measure......
Dongguan HOOHA Electrical Machinery Company Limited
|
GB / T17651.1 - 2 Wire Cable Smoke Density Tester IEC61034 240mm × 140mm
|
Product description: Test the smoke density of the wires and cables Test index: Optical density(OD) and specific optical density(DS) of the smoke Measuring principle: Lambert-beer Law Measuring method: Measure the smoke light transmission percent of ......
Dongguan HOOHA Electrical Equipment Company Limited
|
High Precision Digital Push Pull Dynamometer Force Tester for Measuring 500N 50kg
|
1.High precision and high resolution.Digital display reading is more convenient and quick 2.Five testing modes and three display methods for selection----enhance testing efficiency to the maximum extent. 3.N (Newton), kg (Kilogram) and Ib (Pound) three ......
Yihan (shenzhen) Automation Equipment Co., Ltd.
|
EN 50339&IEC 60332-3 Vertical Flame Spread Tester for Heat Release Test of Cable
|
...Cable Vertical Flame Spread Tester Introduction EN 50399 specifies the tester and methods of test for the assessment of vertical flame spread, heat release and smoke production of vertically-mounted bunched wires or cables, electrical or optical, under defined conditions. EN 50399 details the apparatus and the arrangement and calibration of the instrumentation to be installed in order to measure......
Advanced Instruments Co.,Limited
|
IEC60754 Wire And Cable Testing Machine Halogen Acid Gas Release Tester AC220V
|
...Cable Halogen Acid Gas Release Tester IEC60754 Wire And Cable Halogen Acid Gas Release Tester Product Introduction: The halogen acid gas release measuring device is designed and manufactured according to the test methods GB/T 17650 IEC 60754-1 and IEC 60754-2. It is used to test the halogen gas content, pH value (hydrogen ion content), conductivity, etc. released by wires and cables during combustion. IEC60754 Wire And Cable...
Chongqing gold mechnical and electrical equipment Co., Ltd
|
Submit your “acoustic measurement method tdr cable tester” inquiry in a minute :