ISO16750-4 Clause 4.2 Splash Water Test Chamber Simulating Thermal Shock Testing On Vehicle Caused By Ice Water
|
... shock testing caused by ice water. The purpose is to simulate the splashing of ice water into a heating system or component while driving on a wet road in winter. A failure mode is a temperature expansion coefficient that causes mechanical cracking or...
KingPo Technology Development Limited
|
50 Mm Hole Spacing Splash Water Test Chamber Ipx9k Test Equipment Automatic Water Supply
|
...Splash Water Test Chamber Water Spray Test Equipment ►Applicaton for Waterproof IPX2 Rain Splash Water Test Chamber Water Spray Test Equipment Waterproof Ipx2 Rain Splash Water Test Chamber Water Spray Test Equipment simulates the watet drip environment to test the water......
Xi'An LIB Environmental Simulation Industry
|
0 To 4℃ Temperature Shock With Splash Water Test Chamber For Automotive Components
|
...n driving through puddles. The test serves to verify functioning of the component when subjected to shock-type cooling by means of water. This happens when driving on water roads during the winter. Failure modes are mechanical cracking of the materials or...
Sinuo Testing Equipment Co. , Limited
|
Stainless Steel Waterproof Test Equipment , Splash Water Test Chamber HH0808
|
...,particular requirements for commercial electric cooking ranges, ovens, hobs and hob elements. Application:Simulate rain dripping on the ground, the water splash on...
shanghai kerang technology co ltd
|
VW 80000 Thermal Shock Test Chamber Splash Water Test Equipment MBN LV 124-2 K-12
|
..., Test Conditions and Tests-Part 2: Environmental Requirements” clause 9.12 K-12 Thermal Shock with Splash Water VW-80000:2009-10 “Electric and Electronic Components in Motor Vehicles up to 3.5t General Requirements, Test Conditions and Tests”...
Sinuo Testing Equipment Co. , Limited
|
IEC60335-2-64 Clause 15.1.1 IEC Test Equipment Splash Water Test Device
|
...Test Equipment Splash Water Test Device Product information This splash water test device is according to the standard requirement of IEC60335-2-64 clause 15.1.1 and 15.1.2 to manufacture,In addition, IPX1, IPX2, IPX3 and IPX4 appliances are subjected for 5 min to the following splash test. The apparatus shown in Figure 101 is used. During the test, the water pressure is so regulated that the water splashes......
Guangzhou HongCe Equipment Co., Ltd.
|
Climatic Rapid Temperature Test Chamber Programmable High Temperature Pressure Water Test Chamber
|
....2), IEC60068-2-78, IEC60598-1, GB/T2423.17, GB/T5170.2, GB/T5170.5. The climate chamber is used to test the CFL/LED which meets IES LM-80-08, electricity products, automative cars, home appications and mobiles. What is Climate Chamber? This is used to...
BOTO GROUP LTD
|
Desktop Table Type Condensate Water Test Chamber High And Low Temperature Test Chamber
|
Condensate Water Test Chamber SLN Series Product Introduction: The condensed water test chamber can integrate low temperature, high temperature, and humidity testing into one, and can perform 100% humidity testing. It is an essential testing equipment for ......
Hoyamo and Sinowon Inc
|
IEC60335 Splash Water Test Device 0.4Mpa Gauge With Stainless Steel Bowl
|
...Test Equipment Splash Water Test Device Product information This splash water test device is according to the standard requirement of IEC60335-2-64 clause 15.1.1 and 15.1.2 to manufacture,In addition, IPX1, IPX2, IPX3 and IPX4 appliances are subjected for 5 min to the following splash test. The apparatus shown in Figure 101 is used. During the test, the water pressure is so regulated that the water splashes......
Dongguan Kingpo Technology Limited
|
ipx3 ipx4 spray nozzle against spraying and splashing water test
|
...spray nozzle against spraying and splashing water test Appliance: Spray Nozzle to prove the degrees of protection IPX3 and IPX4 is a hand-held test device to verify protection against spraying and splashing water. The water pressure can be adjusted using......
ALLIED TESTING (HK) CO.,LTD.
|
